![]() The stress tests I ran last times were for 10mins and they all went ok. Is this due to my adjustment in bios?Įxtra edit - I'm getting a nice max cpu temp of 65c - would the thought of pushing to 5.2 be too much?Įdit again - Scrath the above. Question is though, why is it refusing to go lower than 1.329 when I've it set to 1.310 in bios?Įdit - just noticed that VCORE in cpuid hwmonitor the max value is 1.314v. When stress testing with XTU, I'm reading from cpuid hwmonitor the vid voltages as 1.329v with max value of 1.340vĪlthough with my limited knowledge, and with the powers of deduction, I'm assuming the VID voltages in cpuid hwmonitor is related to adjusting the Additional Turbo Mode CPU Core Voltage as my initial value was 1.350 and I witnessed that value in cpuid hwmonitor VID values. I've been dropping the Additional Turbo Mode CPU Core Voltage down by 0.1 then stress testing with XTU but I'm not sure if I'm reading the readings right. IA DC Load Line.0.01)Īnd got a nice stable 5.1 oc. ![]() Max CPU Cache Ratio.50ĬPU Core/Cache Voltage.Adaptive ModeĪdditional Turbo Mode CPU Core Voltage.1.350ĮXTREME TWEAKER -> EXTERNAL DIGI+ POWER CONTROL:ĬPU Load-line Calibration.Level 6ĬPU Current Capability.170% (or as much as possible)ĮXTREME TWEAKER -> INTERNAL CPU POWER MANAGEMENT: SVID Behavior.Best-Case Scenarioġ-Core Ratio Limit.50 I've used x-rated's recommended settings from a previous post. I've been using some info from here to oc my pc. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |